Styrobeck » Formflow

By: Styrobeck Plastics  06-Dec-2011

Styrobeck » Formflow

Styrobecks Form-Flow board is made from 100% recycled (EPS) Polystyrene. Form-Flow is designed to protect below ground waterproofing membranes which are applied to exterior block work, tilt slabs or concrete panel retaining walls.

Form-Flow is installed against the membrane so as to protect the waterproofing seal from the back filling process of scoria,soil ,stone and rock, which could penetrate and break the membrane seal. It is a light weight easy to handle board in a standard size of 2400x1150x90mm.

Because Form-Flow is porous it allows water to pass through the board thus assisting drainage around the waterproofing membrane via the installed drain coil at the base of the application.

Back filling behind the Form-Flow should start with a granular drainage metal such as scoria or sand for a portion of correct thickness prior to the general backfill being put in place. Seek technical advise if in doubt as to the correct backfill material.

Form-Flow has been fully tested and an appraisal was completed by Opus Consultants Ltd.


Contact Styrobeck Plastics

Email

Print this page

Other products and services from Styrobeck Plastics

06-Dec-2011

Styrobeck » Ambionse

A good builder can construct with Ambionse and an Engineer will be required to specify the amount and type of reinforcing required for your specific project. Ambionse Insulated Concrete Formwork provides strong and solid long lasting exterior walls for Residential Homes. Ambionse is energy efficient, acoustically quiet and can provide a fire rating of up to 4 hrs. 190 series blocks 1200mm long x 300mm high x 190mm wide.


06-Dec-2011

Styrobeck » Cut Shapes

Customers will order the most suitable grade for their application, and we cut the polystyrene into the required shape or size. All our polystyrene is manufactured from virgin bead and no regrind is used in our process. Our expert cutting service can cut most 2D shapes and some examples are. Sheet cut with special shaped sides or ends.


06-Dec-2011

Styrobeck » Geofoam

Geofoamâ??s lightweight characteristics provide ease of handling, bulk fill, performance insulation, low water permeability as well as strength and deformation properties that complement every application. GEOFOAM is a solid block of Polystyrene and is available in 5 Â grade options. Bulk filling of large areas.


06-Dec-2011

Styrobeck » Insulation

This microcellular closed cell construction provides EPS with excellent insulating and shock absorbing characteristics with a  high strength to weight ratio. Sheet EPS is cut from a primary block measuring 5.025m x 1.225m x .525m thick. Polystyrene is a lightweight organic cellular plastic insulation material.