Styrobeck » Insulation

By: Styrobeck Plastics  06-Dec-2011
Keywords: Insulation

Styrobeck » Insulation

Polystyrene (EPS) is a lightweight organic cellular plastic insulation material . This microcellular closed cell construction provides EPS with excellent insulating and shock absorbing characteristics with a  high strength to weight ratio. Sheet EPS is cut from a primary block measuring 5.025m x 1.225m x .525m thick. EPS is an inert, organic material that will not rot. EPS is dimensionally stable after kiln drying and will not shrink or sag over time. EPS will last the life of buildings without physical damage. It has been used throughout the world for over 50 years.

For our standard sheet size we offer 2500 x 1200 x thickness required. An option of 2400 x 1200 x thickness, or any length of sheet, can be supplied up to 5 metres (5000mm)

Properties of Various Classes of EPS. AS1366. Part3,1992.
Density. kg/cu.m. 12 15 20 24 28
Compressive Stress at 10% deformation. (min.) Kpa 70 85 105 135 165 AS 2498.3
Cross-breaking strength. (min.) Kpa 135 165 200 260 320 AS 2498.4
Rate of water vapour transmission (max) measured to rise at 23° c. mg/m2s 630 580 520 460 400 AS 2498.6
Dimensional stability of lgth, width, th.(max) at 70’c dry condition.7 days % 1 1 1 1 1 AS 2464.5
m2.K/w 1.25 1.32 1.35 1.39 1.42 AS 2122.1
Flame Propagation Characteristics: s 2 2 2 2 2
Medium flame duration. (max.) s 3 3 3 3 3
Eighth value. (max.) % 18 22 30 40 50
Median volume retained. % 15 19 27 37 47
Eighth value. (min.)

Keywords: Insulation

Contact Styrobeck Plastics

Email - none provided

Print this page

Other products and services from Styrobeck Plastics


Styrobeck » Ambionse

A good builder can construct with Ambionse and an Engineer will be required to specify the amount and type of reinforcing required for your specific project. Ambionse Insulated Concrete Formwork provides strong and solid long lasting exterior walls for Residential Homes. Ambionse is energy efficient, acoustically quiet and can provide a fire rating of up to 4 hrs. 190 series blocks 1200mm long x 300mm high x 190mm wide.


Styrobeck » Cut Shapes

Customers will order the most suitable grade for their application, and we cut the polystyrene into the required shape or size. All our polystyrene is manufactured from virgin bead and no regrind is used in our process. Our expert cutting service can cut most 2D shapes and some examples are. Sheet cut with special shaped sides or ends.


Styrobeck » Formflow

Form-Flow is installed against the membrane so as to protect the waterproofing seal from the back filling process of scoria,soil,stone and rock, which could penetrate and break the membrane seal. Back filling behind the Form-Flow should start with a granular drainage metal such as scoria or sand for a portion of correct thickness prior to the general backfill being put in place. Styrobecks Form-Flow board is made from 100% recycled Polystyrene.


Styrobeck » Geofoam

Geofoamâ??s lightweight characteristics provide ease of handling, bulk fill, performance insulation, low water permeability as well as strength and deformation properties that complement every application. GEOFOAM is a solid block of Polystyrene and is available in 5 Â grade options. Bulk filling of large areas.