Gate Automation | Premier Gates

By: Premier Electronics  06-Dec-2011
Keywords: Gates, Sliding Gate

• • • •

CARRERA for gates up to 800Kg

The Carrera is an electromechanical gear motor with a permanent lithium grease lubrication gearbox. The unlocking device has a personalized key for maximum security and piece of mind. The unit works with mechanical limit switches. It has a built in controller and can also be connected to a back-up battery (24vDC version)

AG2000 for gates up to 1600Kg

The AG2000 is available in two sizes, 1000Kg or 1600Kg. Both motors have a oil bath gearbox for lubrication. The unlocking device has a personalized key for maximum security and piece of mind. The unit works with mechanical limit switches. It has a built in controller inside a lockable lid

VDS produces three types of swing gate actuators

LINEAR

PM1/SC low voltage (24vDC) for gates up to 3m. It is an electro mechanical liner operator and rated for intensive use. Manufactured from aluminium. An emergency override key allows to unlock the mechanism for quick release. Available in three models with 300mm stroke for gate up to 1.6m, 400mm stroke for gates up to 2.5m and 500mm stroke for gates up to 3m

A very powerful actuator designed for intensive use for gates up to 6m wide. It has a built in anti crushing  device with very sensible bypass valves. A manual unlock key allows unlocking during a power failure. There are four model available in this range.

PH for gates up to 1.8m, PH1 for gates up to 3m, PHV240 for gates up to 4m and PHV360 for gates up to 6m

Electro meachnical operator for underground installation. The external self supporting case is made from stainless steel to house the sealed motor and gearbox combination

VDS supply electronic controllers 

for sliding gate motors, single and double swing gate openers, barrier arms & garage door openers

The controllers are made for 12vDC, 24vDC and 230vAC devices. All controllers are fitted with the following features

  • Electronic lock control
  • Safety device inputs
  • Limit switch inputs
  • On board receiver card
  • Speed control
  • Delay control
  • Slow down control

The BEV2 is an electromechanical gear motor with opening and closing micro switches. Compression movement counterbalanced spring that is galvanized. Fitted inside a stainless steel housing with a built in controller and incorporated flashing light on top. Designed for intense use

Remotes

3 Channel self learning transmitter. 433 Mhz

Infra red safety beams. Can be used with lithium batteries or supply power from gate controller making this a very versatile photocell

Single or double underground vehicle detectors. 

Operating voltages range from 12/24v AC or DC to 240vAC

Keywords: Gates, Sliding Gate

Contact Premier Electronics

Email

Print this page

Other products and services from Premier Electronics

06-Dec-2011

Gate Hardware | Premier Gates

80mm U wheel 100mm U wheel 80mm V wheel 100mm V wheel. The hinges for swing gates with a 20mm threaded rod. The nylon rack is used for sliding gate automation. Surface and In Ground steel track for sliding gate. U” profile surface track - Available in 3m and 6m. We stock galvanized post caps for 40x40mm. Ring hinge, Plated Hinge, Long Hinge.