Leaders in GPRS Security Technology - permaconn di

By: Permaconn  06-Dec-2011
Keywords: Alarm Panel

The DI-200 Dialler interface module is designed to operate with both PM1020 & PM1025 outstations, and provides a universal alarm panel dialler interface. This module can be utilised on any alarm panel that can communicate via the Contact ID (CID) reporting format.

The choice is simple. The choice is Permaconn
  • Contact ID panel dialler lead interface.
  • Monitors and reports PSTN failure.
  • Monitors and reports Dialler interface failure
  • Complies with Class 3 AS/NZ 2201.5 (2008)
  • Small size 70 x 50 x 20 mm easy to mount in alarm panel enclosure
  • Automatic switching between PSTN and GPRS
  • Monitors and reports status of alarm panel interface lead
  • Alarm panel status monitor input
  • Non-volatile memory stores all setup information in the event of a power failure
  • Jumper select for PSTN primary reporting
  • Various LED status indicators for easy onsite diagnostics
  • Opertates on 13.8V DC power supplied by Alarm Panel
The choice is simple. The choice is Permaconn

Keywords: Alarm Panel

Contact Permaconn

Email - none provided

Print this page

Other products and services from Permaconn


Leaders in GPRS Security Technology - solutions

Alarm panels may make a phone call every time the panel is armed / disarmed / tested or when an alarm message is sent back to the Central Monitoring station. Permaconn can supply you with an affordable alarm communication system that utilises GPRS to link you to our Central Monitoring station. When a Permaconn signalling device is attached all messages are sent using the GPRS network, saving daily telephone costs.


Leaders in GPRS Security Technology - permaconn network

The data link between the Outstation and the Central station is active at all times, allowing the devices to exchange messages at any time. True Central Station Redundancy is provided by switching between Vodaphone and 2 Degrees GPRS networks - unique to Permaconn. The Central Station Receiver Unit receives the data and sends it to the automation software for processing.


Leaders in GPRS Security Technology - permaconn

With four paths of communication and every signal being acknowledged as ‘sent & received’, you can be guaranteed the right choice has been made. The Permaconn solution is the preferred choice among today’s Security engineers for enhanced security and modern telecommunication demands. All alarm messages have four totally independent paths of communication available - Telco 1 GPRS, Telco 2 GPRS, IP and Phone Line.


Leaders in GPRS Security Technology - permaconn csru

Dual redundancy is built in with both a primary and back up Central Station Receiver unit available to maintain monitoring using independent GPRS networks. The Central Station Receiver Unit is housed in a 19 inch rack mount unit and receives messages from Permaconn outstations. Two serial ports – Port 1 emulates the Ademco 685 receiver – Port 2 connection to serial printer.


Leaders in GPRS Security Technology - permaconn csmu

The Central Station Management Unit is used to send commands to the PM1020 and PM2020 units that are installed in the protected premises. The set up consists of two components – the 19” Permaconn rack mount CSMU and the software. Remotely switch outstations to PSTN to allowtelephone downloading. Remotely operate outputs on Permaconn Outstation.