Arduino and Mindstorm Lego NXT

By: Mindkits  05-Apr-2012

We all enjoyed playing with Lego and I'm sure some still do, but now there is a way to plug it in with Arduino compatible devices! A simple Mind-sensors Multiplexer for NXT Motors adaptation, lets you connect your Lego NXT experiences with Arduino, using a I2C interface. I'm sure this can extent your fun, as you can easily add another one, where Robots need many motors!
There is a video of this running at the bottom of the blog.
Guest Blogger: William George
(Click the heading to read more)


Contact Mindkits

Email - none provided

Print this page

Other news and updates from Mindkits

05-Apr-2012

MindKits News and Blog

Auckmageddon 6 is actually the seventh event of a series that has been running since 1997, and will see up to 400 gamers compete at the North Harbour Stadium for over 48 hours in February. Event organizer Richard Patterson says: “We had such a fantastic response from the previous events that we’re back with even more prizes, bigger network, and even faster internet..


05-Apr-2012

Using the Freetronics LCD Shield to Get a Simple LCD Temperature Readout

This sketch takes some code I'd used previously to print the temperature at 5 second intervals to the serial monitor, and prints it to the LCD instead. If you plug the DS18B20 into the breadboard with the flat face facing towards you, the pins are 1, 2, and 3 from left to tight. Because the LCD shield covers all the pins on the Arduino board, you need a way to connect your temp sensor jumper wires.