Vented Loop | Tru Design Plastics

By: Tru Design Plastics  06-Dec-2011
Keywords: Holding Tank, Reinforced Nylon

Tru-Designs Vented Loop has been designed and manufactured in New Zealand for use in Marine applications.

Vented loops are commonly used for inlet and discharge pipes on toilet installations below the water line. Our aquavent is moulded in a glass reinforced nylon composite, with a silicon bleed valve. The bleed valve allows air into the system to stop syphoning yet seals effectively when water or fluid pass through.

The advantage with our vented loops over others is that the internal diameter is the same throughout the bend - meaning there is no restriction.

The aquavent can be used as a holding tank vent by replacing the bleed valve fitting with a tube that is connected to a deck level vent.

Aquavents are available in three sizes, in either black or white :

90319 Vented Loop 19mm White
90321 Vented Loop 25mm White
90323 Vented Loop 38mm White

90318 Vented Loop 19mm Black

90320 Vented Loop 25mm Black

90322 Vented Loop 38mm Black

It is recommended that servicing is conducted yearly on vented loops to ensure their effectiveness. A spare parts and service kit is available;

90325 Spare Parts Vented Loop White
90324 Spare Parts Vented Loop Black

Keywords: Holding Tank, Reinforced Nylon

Other products and services from Tru Design Plastics


Aquavalve Electronic | Tru Design Plastics

The success of the Aquavalve and positive response from the marine industry led our design team to develop the Electronic Aquavalve, which has become a problem solver for many modern marine plumbing installations. The Electronic Aquavalve allows the diverting valve to be operated with the push of a button on the supplied control panel.


Tail Long Thread 90° Bend

This range of Long Thread 90 deg Tails are designed to screw into the range of Ball Valves but can also be used in many applications. Moulded in Glass Reinforced composite Nylon 6 these Tails are also suitable for use in contact with Petrol and Diesel. 90517 Tail 13mm ½" BSP Long Thread 90° Bend.


Vented Loop With Solenoid Valve

When the toilet pump is stopped the solenoid opens to then act as a syphon break to stop water syphoning back into the toilet system the same way that a manual vented loop operates. The Solenoid activated Vented Loop is designed to be fitted into the intake pipe for a Electric Toilet and wired to the Toilet operating switch. When the toilet pump is operated water is sucked the solenoid shuts off to allow maximum intake flow.


Connector 90° | Tru Design Plastics

To combat this we have available the 90° Connector, allowing hose to be run into corners and around edges of bulkheads. When plumbing in the tight confines of a boat, the bend radius for flexible hose can lead to messy installations. Manufactured in a glass reinforced nylon composite.


Skin Fittings | Tru Design Plastics

Designed and manufactured in New Zealand, our Skin Fittings are manufactured in a special grade of glass reinforced nylon composite, resulting in a quality product with high impact and tensile strength. 90424 Skin Fitting ½" BSP Black90431 Skin Fitting ¾" BSP Black90422 Skin Fitting 1" BSP Black90420 Skin Fitting 1 ¼" BSP Black90418 Skin Fitting 1 ½" BSP Black90428 Skin Fitting 2" BSP Black.