Tail Long Thread 90° Bend

By: Tru Design Plastics  06-Dec-2011
Keywords: Ball Valves

This range of Long Thread 90 deg Tails are designed to screw into the range of Ball Valves but can also be used in many applications. Moulded in Glass Reinforced composite Nylon 6 these Tails are also suitable for use in contact with Petrol and Diesel.

90517 Tail 13mm ½" BSP Long Thread 90° Bend

90372 Tail 19mm ¾" BSP Long Thread 90° Bend

90373 Tail 25mm 1" BSP Long Thread 90° Bend

90374 Tail 32mm 1¼" BSP Long Thread 90° Bend

90375 Tail 38mm 1½" BSP Long Thread 90° Bend

90376 Tail 50mm 2" BSP Long Thread 90° Bend

Unequal

90529 Tail 38mm 1¼" BSP Long Thread 90° Bend

Keywords: Ball Valves

Other products and services from Tru Design Plastics

06-Dec-2011

Aquavalve Electronic | Tru Design Plastics

The success of the Aquavalve and positive response from the marine industry led our design team to develop the Electronic Aquavalve, which has become a problem solver for many modern marine plumbing installations. The Electronic Aquavalve allows the diverting valve to be operated with the push of a button on the supplied control panel.


06-Dec-2011

Vented Loop With Solenoid Valve

When the toilet pump is stopped the solenoid opens to then act as a syphon break to stop water syphoning back into the toilet system the same way that a manual vented loop operates. The Solenoid activated Vented Loop is designed to be fitted into the intake pipe for a Electric Toilet and wired to the Toilet operating switch. When the toilet pump is operated water is sucked the solenoid shuts off to allow maximum intake flow.


06-Dec-2011

Connector 90° | Tru Design Plastics

To combat this we have available the 90° Connector, allowing hose to be run into corners and around edges of bulkheads. When plumbing in the tight confines of a boat, the bend radius for flexible hose can lead to messy installations. Manufactured in a glass reinforced nylon composite.


06-Dec-2011

Vented Loop | Tru Design Plastics

The aquavent can be used as a holding tank vent by replacing the bleed valve fitting with a tube that is connected to a deck level vent. The bleed valve allows air into the system to stop syphoning yet seals effectively when water or fluid pass through. Tru-Designs Vented Loop has been designed and manufactured in New Zealand for use in Marine applications. 90325 Spare Parts Vented Loop White90324 Spare Parts Vented Loop Black.


06-Dec-2011

Skin Fittings | Tru Design Plastics

Designed and manufactured in New Zealand, our Skin Fittings are manufactured in a special grade of glass reinforced nylon composite, resulting in a quality product with high impact and tensile strength. 90424 Skin Fitting ½" BSP Black90431 Skin Fitting ¾" BSP Black90422 Skin Fitting 1" BSP Black90420 Skin Fitting 1 ¼" BSP Black90418 Skin Fitting 1 ½" BSP Black90428 Skin Fitting 2" BSP Black.