Aquavalve Electronic | Tru Design Plastics

By: Tru Design Plastics  06-Dec-2011
Keywords: Control Panel, Marine Plumbing, Holding Tank

We have been producing the Aquavalve for many years. The success of the Aquavalve and positive response from the marine industry led our design team to develop the Electronic Aquavalve, which has become a problem solver for many modern marine plumbing installations.

The Electronic Aquavalve allows the diverting valve to be operated with the push of a button on the supplied control panel. The indicators on the control panel show the current position of the valve. The valve has two positions 'holding tank' or 'overboard'.

Available in 2 models :

Weight 1.5 Kilo

90344 Aquavalve Electronic EA015 plus Control Panel CP05 12V
90346 Aquavalve Electronic EA015 plus Control Panel CP05 24V

Features :
* Electronic activation of the Aquavalve from included control panel
* Clear indication on control panel as to current valve position
* Versatility of installation with a vast range of hose and bend adaptors
* Compatible with Manual Aquavalve adaptors
* Stainless steel fastenings
* Each valve seal tested to check no o’ring leakage
* The valve has been tested to 300 PSI

** Note: 2 button control panel is being phased out in favour of 3 button panel (pictured)

Keywords: Control Panel, Holding Tank, Marine Plumbing

Other products and services from Tru Design Plastics

06-Dec-2011

Tail Long Thread 90° Bend

This range of Long Thread 90 deg Tails are designed to screw into the range of Ball Valves but can also be used in many applications. Moulded in Glass Reinforced composite Nylon 6 these Tails are also suitable for use in contact with Petrol and Diesel. 90517 Tail 13mm ½" BSP Long Thread 90° Bend.


06-Dec-2011

Vented Loop With Solenoid Valve

When the toilet pump is stopped the solenoid opens to then act as a syphon break to stop water syphoning back into the toilet system the same way that a manual vented loop operates. The Solenoid activated Vented Loop is designed to be fitted into the intake pipe for a Electric Toilet and wired to the Toilet operating switch. When the toilet pump is operated water is sucked the solenoid shuts off to allow maximum intake flow.


06-Dec-2011

Connector 90° | Tru Design Plastics

To combat this we have available the 90° Connector, allowing hose to be run into corners and around edges of bulkheads. When plumbing in the tight confines of a boat, the bend radius for flexible hose can lead to messy installations. Manufactured in a glass reinforced nylon composite.


06-Dec-2011

Vented Loop | Tru Design Plastics

The aquavent can be used as a holding tank vent by replacing the bleed valve fitting with a tube that is connected to a deck level vent. The bleed valve allows air into the system to stop syphoning yet seals effectively when water or fluid pass through. Tru-Designs Vented Loop has been designed and manufactured in New Zealand for use in Marine applications. 90325 Spare Parts Vented Loop White90324 Spare Parts Vented Loop Black.


06-Dec-2011

Skin Fittings | Tru Design Plastics

Designed and manufactured in New Zealand, our Skin Fittings are manufactured in a special grade of glass reinforced nylon composite, resulting in a quality product with high impact and tensile strength. 90424 Skin Fitting ½" BSP Black90431 Skin Fitting ¾" BSP Black90422 Skin Fitting 1" BSP Black90420 Skin Fitting 1 ¼" BSP Black90418 Skin Fitting 1 ½" BSP Black90428 Skin Fitting 2" BSP Black.