VIBROWEB XP – Expert Level

By: Alignment Engineering  06-Dec-2011
Keywords: Condition Monitoring, Pc Software, Online Condition Monitoring

Diagnostic Online Condition Monitoring

  • Extruders
  • Process ventilators
  • Special drives
  • Remote pumping stations
  • Emergency power supplies (UPS)
VIBROWEB XP runs through the programmed measurement tasks autonomously – even without a PC connection. As an intelligent diagnostic robot, it detects different operating states of a system and independently adapts the recording and evaluation of the measured data to these states. Features:
  • Operating-state-dependent measurement and alarms
  • Machine diagnostics with time waveform, spectrum (amplitude, envelope), inegration of the spectrum, order analysis, cepstrum
  • Fast measurement channel switchover - ideal for variable operating conditions, such as changes in load & RPM
  • Also suitable for machines with low RPM
  • Compact, simple installation – ideal for individual aggregates
  • Connection for LineDrive or ICP accelerometers
  • Autonomous in operation - measurement, evaluation, saving, alarm notification without a PC connection
  • Sending of measurement data, remote access and remote control via Ethernet, modem or radio – ideal for service staff!
  • User-friendly data evaluation and measurement settings with OMNITREND PC software

Keywords: Condition Monitoring, Online Condition Monitoring, Pc Software,

Contact Alignment Engineering

Email - none provided

Print this page

Other products and services from Alignment Engineering



Machine vibration, bearing condition, pump cavitation, temperature and RPM can all be easily measured using built-in transducers - with no cumbersome cables or external sensors. VIBROTIP is an extremely rugged and easy-to-use hand-held data collector for five key indicators of machine condition.



The OMNTREND software processes the data and checks whether any limits have been exceeded. For the visualization, the data are displayed graphically in a diagram. You can use it to transfer the stored measurement results to your PC. VIBSCANNER is also a data collector.



VIBXPERT is a high performance, full-featured 1 or 2 channel FFT data collector and signal analyzer which allows easy condition monitoring of equipment found in many industries such as power generation, petrochemical, pulp and paper.



VIBNODE is a small monitoring system which was specially developed for production-critical standard machines. Its hardware and software are perfectly tuned to measure signals from low-speed machines. Simple installation directly on the machine – lower installation costs. Perfect entry level solution for Online Condition Monitoring. Easy operation with the proven OMNITREND software. Standard interfaces– connection to Ethernet.


VIBROWEB – Advanced Level

Time waveform, spectrum, integration of the spectrum, envelope, orbit, shock pulse, acceleration , vibration velocity. This dynamic system can be configured and changed in the field to accept a wide variety of sensor technologies. VIBROWEB is the automated solution to an existing route-based CbM Program. A “Plug-N Play” card configures each sensor for up to 32 channels. The Black Box Technology replaces pre-installed switch boxes.