VIBROWEB – Advanced Level

By: Alignment Engineering  06-Dec-2011
Keywords: Data Collection, Pc Software

Plug-N Play' Online Condition Based Machine Monitoring

VIBROWEB is the automated solution to an existing route-based CbM Program. The Black Box Technology replaces pre-installed switch boxes, connected to permanently mounted transducers. This dynamic system can be configured and changed in the field to accept a wide variety of sensor technologies. A “Plug-N Play” card configures each sensor for up to 32 channels. Eight additional inputs are available for speed measurements. All sensors are powered simultaneously to greatly reduce data collection cycle time!

Remote monitoring of production machinery can be accomplished from the comfort of your office. Alarm notifications and tele-diagnosis is accomplished through any Internet browser.

  • Standard machines (motor, pump, fan,..)
  • Machines with variable speed/ load (gear, extruder)
  • Sleeve bearings
Features:
  • Compatible to almost any sensor type (ICP, PT100, strain gage,..)
  • 32 analog inputs (16x2 synchronous)
  • 8 Tacho/ Pulse inputs
  • 4 digital inputs / 4 digital outputs
  • Measures and stores: Time waveform, spectrum, integration of the spectrum, envelope, orbit, shock pulse, acceleration (RMS), vibration velocity (peak, RMS)
  • Plug-in cards for signal conditioning
  • Short meas. cycles (typical 2 minutes)
  • Programmed via OMNITREND PC software
  • Networked (Ethernet / Internet)
  • Stand-alone - no PC required
  • Sophisticated alarming

Keywords: Data Collection, Pc Software

Contact Alignment Engineering

Email - none provided

Print this page

Other products and services from Alignment Engineering

06-Dec-2011

Vibrotip

Machine vibration, bearing condition, pump cavitation, temperature and RPM can all be easily measured using built-in transducers - with no cumbersome cables or external sensors. VIBROTIP is an extremely rugged and easy-to-use hand-held data collector for five key indicators of machine condition.


06-Dec-2011

VIBSCANNER

The OMNTREND software processes the data and checks whether any limits have been exceeded. For the visualization, the data are displayed graphically in a diagram. You can use it to transfer the stored measurement results to your PC. VIBSCANNER is also a data collector.


06-Dec-2011

Vibexpert

VIBXPERT is a high performance, full-featured 1 or 2 channel FFT data collector and signal analyzer which allows easy condition monitoring of equipment found in many industries such as power generation, petrochemical, pulp and paper.


06-Dec-2011

VIBNODE

VIBNODE is a small monitoring system which was specially developed for production-critical standard machines. Its hardware and software are perfectly tuned to measure signals from low-speed machines. Simple installation directly on the machine – lower installation costs. Perfect entry level solution for Online Condition Monitoring. Easy operation with the proven OMNITREND software. Standard interfaces– connection to Ethernet.


06-Dec-2011

VIBROWEB XP – Expert Level

It detects different operating states of a system and independently adapts the recording and evaluation of the measured data to these states. Sending of measurement data, remote access and remote control via Ethernet, modem or radio – ideal for service staff. VIBROWEB XP runs through the programmed measurement tasks autonomously – even without a PC connection.