VIBNODE

By: Alignment Engineering  06-Dec-2011
Keywords: Condition Monitoring, Online Condition Monitoring

Perfect entry level solution for Online Condition Monitoring

VIBNODE is a small monitoring system which was specially developed for production-critical standard machines:

Features:
  • Economical entry-level solution with 6 or 12 channels
  • Simple installation directly on the machine – lower installation costs
  • Standard interfaces– connection to Ethernet
  • Easy operation with the proven OMNITREND software
  • Broadband and narrowband monitoring
  • Masks out noise signals
  • RPM-dependent tracking of frequency bands
  • Intelligent data reduction
  • Independent alarm generation
  • On-site intelligence: complete signal processing in VIBNODE
VIBNODE 'Low Speed' – Slow Mover

Perfect solution for low-speed machines

VIBNODE 'Low-Speed' is based on the VIBNODE standard system. Its hardware and software are perfectly tuned to measure signals from low-speed machines.

Features:

  • 16 bit ADC
  • Autoranging
  • 4 amplification stages: 1, 10, 100, 1000
  • Special filters for low-speed machines

Keywords: Condition Monitoring, Online Condition Monitoring

Contact Alignment Engineering

Email - none provided

Print this page

Other products and services from Alignment Engineering

06-Dec-2011

Vibrotip

Machine vibration, bearing condition, pump cavitation, temperature and RPM can all be easily measured using built-in transducers - with no cumbersome cables or external sensors. VIBROTIP is an extremely rugged and easy-to-use hand-held data collector for five key indicators of machine condition.


06-Dec-2011

VIBSCANNER

The OMNTREND software processes the data and checks whether any limits have been exceeded. For the visualization, the data are displayed graphically in a diagram. You can use it to transfer the stored measurement results to your PC. VIBSCANNER is also a data collector.


06-Dec-2011

Vibexpert

VIBXPERT is a high performance, full-featured 1 or 2 channel FFT data collector and signal analyzer which allows easy condition monitoring of equipment found in many industries such as power generation, petrochemical, pulp and paper.


06-Dec-2011

VIBROWEB – Advanced Level

Time waveform, spectrum, integration of the spectrum, envelope, orbit, shock pulse, acceleration , vibration velocity. This dynamic system can be configured and changed in the field to accept a wide variety of sensor technologies. VIBROWEB is the automated solution to an existing route-based CbM Program. A “Plug-N Play” card configures each sensor for up to 32 channels. The Black Box Technology replaces pre-installed switch boxes.


06-Dec-2011

VIBROWEB XP – Expert Level

It detects different operating states of a system and independently adapts the recording and evaluation of the measured data to these states. Sending of measurement data, remote access and remote control via Ethernet, modem or radio – ideal for service staff. VIBROWEB XP runs through the programmed measurement tasks autonomously – even without a PC connection.